![]() ![]() The TITAN series autoloaders were designed for just such an occasion. Why should I purchase a standalone autoloader instead of one controlled by a PC?.Not to mention that if one of the components needs to be returned for repair, the other component is still available to perform the other half of the job without waiting. Not only are the TITAN series autoloaders more cost effective than other units on the market, but also allow for the addition of a separate printer at a lower cost than a combined printer duplicator unit. In contrast, buying two separate units will save money as well. This will save time by conserving the number of man hours needed to produce the final count of duplicated discs. If you separate the two processes, you can print during regular operating hours and duplicate after hours using a TITAN series autoloader. It takes approximately 6 minutes to duplicate a full DVD while a typical inkjet printer takes approximately 30 seconds to print on a disc. Time and Expense: The duplication process is generally slower than the printing process.Any errors or glitches generated by the PC will negatively affect the printer and make reliable overnight operation near impossible. The PC could freeze in the middle of the job and halt the entire process whereas a standalone unit does not rely on a PC to function. A PC operated device is typically not as reliable as a standalone unit dedicated to a single function. PC connection: Printers require a PC connection in order to operate while the autoloader is a completely standalone unit.Where, if the autoloader ran without a printer, at least the duplication aspect would be completed and the printing could be finished at a later time. It won’t be possible as the autoloader will stop after 100 discs as the printer runs out of ink/ribbon. After two runs, there is only enough ink/ribbon for 100 discs, but 200 discs need to be produced. ![]() ![]() Instead, perhaps a typically run is a quantity of 200 discs. If the 1000 disc TITAN PRO is in use, at most only half the job will be printed, leaving 500 discs to be completed. On average, the maximum lifespan for a single ink cartridge or thermal ribbon transfer is approximately 500 discs. Ink and Ribbons are finite commodities that run out after a certain number of prints. Ink/Ribbon Limitations: All printers require some form of ink or thermal ribbon to function. ![]() Adding a printer to the autoloader will negatively affect the autoloaders ability due to the following reasons: To ensure proper operation and the ability to duplicate the greatest number of discs in the shortest amount of time, it's best to separate the printing and duplication functions. The primary function of an autoloader is for continuous unsupervised operation with the ability to run overnight. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |